| Depth |
29.5 mm |
| Depth (inches) |
1.161 inch |
| Height |
83 mm |
| Height (inches) |
3.268 inch |
| Width |
26.5 mm |
| Width (inches) |
1.043 inch |
| Net weight |
91 g |
| Storage temperature |
-40 °C…90 °C |
| Humidity at storage temperature |
95 %, no condensation |
| Operating temperature |
-35 °C…50 °C |
| Humidity at operating temperature |
20 to 90% RH |
| RoHS Compliance Status |
Compliant with exemption |
| RoHS Exemption (if applicable/known) |
7a, 7cI |
| REACH SVHC |
Lead 7439-92-1 |
| SCIP |
c40c4197-e4ff-4c59-8a6f-82632592ebb9 |
| AC input voltage range |
85 … 305 V AC |
| Frequency range AC |
47…63 Hz |
| Input current |
450 mA |
| Input fuse |
2 A time-lag fuse (internal) |
| Inrush current (typ.) |
40 A |
| Load regulation (typ.) |
2 % |
| Rated input voltage |
100…277 V AC |
| Start-up time, max. |
150 ms |
| Capacitive load |
6.000 µF |
| Load regulation (typ.) |
2 % |
| Mains failure bridge-over time |
Mains failure bridge-over time, min.: 8 ms Input voltage type: AC Input voltage: 100 V Output current: 1,667 mA Output voltage: 12 V Mains failure bridge-over time, min.: 30 ms Input voltage type: AC Input voltage: 230 V Output current: 1,667 mA Output voltage: 12 V Mains failure bridge-over time, min.: 50 ms Input voltage type: AC Input voltage: 277 V Output current: 1,667 mA Output voltage: 12 V |
| Max. residual ripple |
120 mVss |
| Output power |
20 W |
| Overload protection |
120 … 180 %, switch off mode |
| Rated output voltage |
12 V DC ± 3 % |
| Degree of efficiency (typ.) |
87 % |
| EMC standards |
EN IEC 61204-3 |
| MTBF |
According to Standard: MLT-HDBK-217F Operating time (hours), min.: 1,000,000 h Ambient temperature: 25 °C Input voltage: 230 V Output power: 20 W Duty cycle: 100 % |
| Power loss, idling |
100 mW |
| Protection degree |
IP30 |
| Short-circuit protection |
Yes |
| Standards |
EN 60335-1 |
| Surge voltage category |
III |
| Weight |
70.6 g |
| Humidity at storage temperature |
95 %, no condensation |
| Insulation voltage, input/output |
4 kV |
| Protection class |
II |
| Surge voltage category |
III |
| Safety extra-low voltage |
SELV according to EN 62368-1 |
| Safety transformers for switch-mode power supplies |
According to EN 61558-2-16 |
| Conductor cross-section, AWG/kcmil , max. |
12 AWG |
| Conductor cross-section, AWG/kcmil , min. |
26 AWG |
| Conductor cross-section, rigid , max. |
2.5 mm² |
| Conductor cross-section, rigid , min. |
0.2 mm² |
| Number of terminals |
2 (L,N) |
| Stripping length (input) |
10 mm |
| Conductor cross-section, AWG/kcmil , max. |
14 AWG |
| Conductor cross-section, AWG/kcmil , min. |
28 AWG |
| Conductor cross-section, rigid , max. |
1.5 mm² |
| Conductor cross-section, rigid , min. |
0.2 mm² |
| Number of terminals |
2 (+ / -) |
| Stripping length (output) |
10 mm |
| LED green |
Operating voltage OK |
Reviews
There are no reviews yet.