Clamping yoke (bus-bar), Clamping yoke, black, 4 mm², Width: 7 mm, M 3, Steel
Technical Specifications:
| Depth | 20.4 mm |
| Depth (inches) | 0.803 inch |
| Height | 19 mm |
| Height (inches) | 0.748 inch |
| Width | 7 mm |
| Width (inches) | 0.276 inch |
| Net weight | 3.72 g |
| Ambient temperature | -5 °C…40 °C |
| RoHS Compliance Status | Compliant without exemption |
| REACH SVHC | No SVHC above 0.1 wt% |
| Material | Steel |
| Insulating material | PA |
| Colour | black |
| Ex 2014/34/EU label | II 2 G D |
| Safety notice | Installation instructions:The potential equalisation (PE) rail modules are suitable for use in housings in atmospheres with flammable gases and dust. For use in areas with flammable gases, these housings must meet the requirements of EN 60079-0 and EN 60079-7. For use in areas with flammable dust, these housings must meet the requirements of EN 60079-0 and EN 60079-31.When combined with other terminal block ranges and sizes, and when other accessories are used, you must comply with the clearance and creepage distances given.Regarding accessory use, the manufacturer’s instructions must be followed. List of restrictions: The PE rail modules are considered one component, with Ex marking when used with the busbar holders of type SH and WEW. When used independently, the above named components are not covered by this certificate. |
| Version | for busbar 10 x 3 mm |
| Installation advice | Feed-through (bushing) |
| Type of mounting | when screwed in |
| Clamping range, max. | 6 mm² |
| Clamping range, min. | 0.5 mm² |
| Clamping screw | M 3 |
| Tightening torque, max. | 1 Nm |
| Tightening torque, min. | 0.5 Nm |
| Type of connection | Clamping yoke |
| Wire connection cross section, finely stranded, max. | 4 mm² |
| Wire connection cross section, finely stranded, min. | 0.5 mm² |
| Wire connection cross-section, solid core, max. | 6 mm² |
| Wire connection cross-section, solid core, min. | 0.5 mm² |
| Certificate No. (CSA) | 12400-237 |
| Wire cross section max. (CSA) | 10 AWG |
| Wire cross section min. (CSA) | 26 AWG |
| TS 35 offset | 41 mm |
| Installation advice | Feed-through (bushing) |
| Rated cross-section | 4 mm² |
| Certificate No. (UR) | E60693 |
| Conductor size Factory wiring max. (UR) | 12 AWG |
| Conductor size Factory wiring min. (UR) | 20 AWG |
| Conductor size Field wiring max. (UR) | 12 AWG |
| Conductor size Field wiring min. (UR) | 20 AWG |
Reviews
There are no reviews yet.